150
SEAV
The duplication process should be carried out in the
immediate proximity of the receiver CU.
1. Press and hold the already operating RC button in the
receiver.
2. The receiver enters programming mode.
3. Press the new RC button.
NB: if the memorisation process is not successful, act directly
on the receiving CU in the following way:
1. Press and release the programming button (called PROG. or
MEMO). LED on the receiver will light up.
2. Press the new RC button (to be coded). LED on the receiver
will light steady.
3. Repeat the procedure for as many buttons as you want to
program.
If the process is not successful or if errors are made during
programming, wait 20 seconds and start the programming
process again from point 1.
BE HAPPY RS2
Cod. 6900918
Be Happy RS1 Black, Be Happy RS2 Black, Be Happy RS3 Black
433.92 MHz
Rolling code
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
LITE
To Next Page
Loading...