140
PRASTEL
The duplication process should be carried out in the
immediate proximity of the receiver CU.
1. Place the already programmed transmitted in close
proximity to the receiver (1-2 m).
2. Press buttons 1 and 2 simultaneously and release them:
LED lights up and goes out after about 2 seconds.
3. When LED lights up again, press buttons 1 and 2 again at
the same time and keep them pressed until LED starts
flashing.
4. At the end of the flashing the TX makes a transmission,
activating the receiver learning mode.
5. Within 10 seconds, press one of the buttons of the SLIM+
transmitter that you want to enter in the receiver’s memory.
SLIM+
Cod. 6900981
433.92 MHz
Rolling code 128 BIT
To Next Page
Loading...