154
SERAI
1. Remove the button cover by prying it o with a screwdriver
in the slot at the bottom.
2. Position both RCs with LED facing the viewer, taking care to
keep the new one to the left and the one already working on
the right.
3. Press the hidden button on the new RC using a pin.
4. Press the hidden button of the old (working) RC with a pin.
5. Bring the original RC closer (within 30 seconds) to the clone,
then press and release button 1.
If the process is not successful or if errors are made during
programming, wait 20 seconds and start the programming
process again from point 1.
OG 2S
Cod. 6900957
433.92 MHz
Rolling code
To Next Page
Loading...