48
IMPORTANT: CHECK THAT THE REMOTE CONTROL TO BE COPIED IS A MASTER.
By pressing any button, LED must emit a double flash instead of turning on immediately with a steady light.
press the button
to copy
press and hold button 1
and meanwhile
press 4 times button 2
LED flashes
every 2 sec.
LED flashes fast
press the button
where you want
to memorise the code
ROLLING SIMPLE
press the button
to copy
press buttons 1 and 2 of the
BFT transmitter (source code)
simultaneously **
press and hold button 1
and meanwhile
press 4 times button 2
LED flashes
every 2 sec.
LED double flashing LED flashes fast
press the button where you
want to memorise
the code until the LED goes out
ROLLING COMPLEX (BFT MITTO)
press the button
to copy
press both buttons
together (DIAGONAL
BUTTONS) and release
them when LED flashes
(source code)
while LED flashes press
the button to copy
press and hold button 1
and meanwhile
press 4 times button 2
LED flashes
every 2 sec.
fast LED double flashing LED flashes fast
press the button where you
want to memorise
the code until the LED goes out
ROLLING COMPLEX (FAAC/GENIUS)
*See compatibility list
**In older versions, using one
pin press the hidden button at the back
of the transmitter.
x4
x4
x4
WHY SYNC TECHNOLOGY
RECEIVER INSERTION
PROCEDURE*
WHY SYNC TECHNOLOGY
ACTION ON RECEIVER
REQUIRED
RECEIVER INSERTION
PROCEDURE
RECEIVER INSERTION
PROCEDURE
DIRECT FUNCTION
COMPATIBLE RCs
COMPATIBLE RCs
21 4
3
5 6
21 4
3
6
5
7 8
21 4
3 5 6
7 8 9
To Next Page
Loading...