1 After starting, the device loads the last permanently stored internal parameter set
to its working memory.
2 The device then searches for a valid parameter set in the optional memory card
slot. If there is a positive search result, the device uses this parameter set to over‐
write the existing parameter set in its working memory.
3 If the PROFINET controller sends a parameter set via the PROFINET with central
configuration of the bus users, the device again overwrites corresponding parame‐
ter values in its working memory. These changes are lost again when the device is
switched off. The PROFINET controller must then again send the most recently
valid parameter values each time the device is restarted (supply voltage is
switched on).
Removing the memory card from the device:
NOTICE
Risk of damage to the memory card!
b
To avoid damaging the memory card, make sure the device is de-energized when
you insert or remove the card. For this purpose, disconnect the device from the
supply voltage accordingly.
1. Switch off the supply voltage to the device.
2. Open the black rubber cover.
To do so, carefully lift the flap of the rubber cover.
3. Unlock the memory card in the slot and remove it.
To do so, carefully press down once on the memory card.
4. Close the rubber cover. Make sure that the cover is completely flush with the hous‐
ing.
5. Switch on the supply voltage for the device.
Support Portal
NOTE
In the SICK Support Portal (supportportal.sick.com, registration required) you will find,
besides useful service and support information for your product, further detailed infor‐
mation on the available accessories and their use.
3 PRODUCT DESCRIPTION
24
O P E R A T I N G I N S T R U C T I O N S | CLV61x DualPort (PROFINET) 8017842/ZOK7/2019-02-01 | SICK
Subject to change without notice
To Next Page
Loading...
