Further topics
•
"R
eset to factory settings", page 86
•
"Configuring beam coding", page 88
7.13.3 Connecting preconfigured devices in an existing cascade
If you use a device that may already have been configured to extend a cascade or to
r
eplace a (defective) device in a cascade, reset the device to the factory settings first.
Further topics
•
"R
eset to factory settings", page 86
•
"Connecting a new device in an existing cascade", page 99
•
"Configuring beam coding", page 88
7.14 Status indication on both sides
The OSSD status and the status of the protective field are indicated via LEDs on the
sender and r
eceiver when the following applies:
•
The sender and receiver are connected to one another in the control cabinet
•
The sender and receiver are connected to one another via a T-connector
The status information is transferred from the receiver to the sender automatically. A
configuration process is not required.
Further topics
•
"C
onnection of sender and receiver", page 51
7 C
ONFIGURATION
100
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex II 3GD 8023872/18YZ/2021-01-14 | SICK
Subject to change without notice
To Next Page
Loading...
