SICK deTec4 Ex II 3GD - Sender and Receiver Alignment; Aligning the Sender and Receiver

Further topics
•
"C
onfiguration mode", page 88
•
"Indications when switching on", page 115
8.4 Sender and receiver alignment
Overview
Onc
e mounting and electrical installation are complete, the sender and receiver must
be aligned with each other.
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during the alignment process.
b
Make sure that the outputs of the safety light curtain do not affect the machine
during the alignment process.
NOTE
W
hile aligning to the indication of the alignment quality, pay attention to the synchro‐
nization indication of the topmost and bottommost beam and the bracket with which
the sender and receiver are attached.
Further topics
•
"Ali
gnment with the QuickFix bracket", page 105
•
"Alignment with the FlexFix bracket or with the upgrade bracket", page 105
•
"Indication of the alignment quality", page 106
•
"Diagnostic LEDs", page 115
8.4.1 Aligning the sender and receiver
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during the alignment process.
b
Make sure that the outputs of the safety light curtain do not affect the machine
during the alignment process.
DANGER
Hazard due to lack of effectiveness of the protective device
The integrated laser alignment aid switches the OSSDs to the OFF state.
b
Make sure that the outputs of the safety light curtain do not have any effect on the
machine when the integrated laser alignment aid is activated.
b
Only use the integrated laser alignment aid to align the safety light curtain.
COMMISSIONING 8
8023872/18YZ/2021-01-14 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex II 3GD
103
Subject to change without notice