SICK deTec4 Ex II 3GD - Mounting the Flexfix Bracket

Mount QuickFix bracket on a machine or profile frame
T
able 17: Side and rear mounting with the QuickFix bracket
Mounting
me
thod
Description
On the side Fasten the M5 screw to the machine or profile frame through the QuickFix
bracket. A screw nut or threaded hole is required on the machine or profile
frame (!).
Fasten the M5 screw to the QuickFix bracket through the machine or profile
fr
ame. A screw nut is required for each QuickFix bracket (").
Fasten the M5 screw to the profile frame through the QuickFix bracket. A
slidin
g nut is required on the profile frame (§).
On the back Fasten the M5 screw to the machine or profile frame through the QuickFix
br
acket. A screw nut or threaded hole is required on the machine or profile
frame ($).
!
§
$
"
a
b
a
b
Figure 39: Mounting the QuickFix bracket to a profile
5.4.2 Mounting the FlexFix bracket
Overview
In t
he FlexFix bracket, the sender and receiver can be rotated ± 15° around their
longitudinal axis.
2 FlexFix brackets are used to mount the sender and receiver.
As a rule, each FlexFix bracket is mounted to the mounting surface with 2 screws. In
exceptional cases (e.g. reduced vibration and shock requirements), a FlexFix bracket
can be mounted with only one screw if this does not impair the function.
5 MOUN
TING
72
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex II 3GD 8023872/18YZ/2021-01-14 | SICK
Subject to change without notice