The SP2 system plug is only used on the receiver of a host system or single system. The
SP1 s
ystem plug is used on all other receivers of the guest systems and on all senders.
The system plugs are available in the following versions:
•
System plug with 5-pin system connection
•
System plug with 8-pin system connection
•
System plug with 5-pin system connection and 5-pin extension connection
•
System plug with 8-pin system connection and 5-pin extension connection
Prerequisites
•
T
he SP2 system plug can only be used with receivers that have the digit 1 at the
following position of their type code:
C4P-E*****1***
Use of system plugs in a single system and in a cascade
T
able 4: Use of SP1 system plug in a single system
SP1 system plug type code
1000 1200 1100 1300
Sender
✓
✓
1)
✓
2)
✓
1)
2)
Receiver
✓
•
Be
am coding
✓
•
Be
am coding
•
Restart inter‐
lock
•
External
device moni‐
toring
•
Application
diagnostic
output
✓
•
Be
am coding
•
Restart inter‐
lock
•
External
device moni‐
toring
•
Application
diagnostic
output
•
IO-Link
✓
•
Be
am coding
•
Restart inter‐
lock
•
External
device moni‐
toring
•
Application
diagnostic
output
•
IO-Link
✓
SP1 system plug suitable.
1)
At the sender, the 8-pin system connection is solely for the purposes of providing standardized wiring. It
is par
ticularly recommended if the 8-pin system connection at the receiver is used and the sender and
receiver are connected to each other via a T-connector.
2)
If a sender does not have an additional guest connected to it, the extension connection has no function
and mus
t be sealed with a protective cap.
3 PRODUCT DESCRIPTION
18
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex II 3GD 8023872/18YZ/2021-01-14 | SICK
Subject to change without notice
To Next Page
Loading...
