SICK MARSIC200 User Manual

1 About this document
1.1 Function of this document
This document describes:
•
Installation
•
Initial start-up
•
Operation via SOPAS ET
NOTICE
This Manual is only valid in combination with the MARSIC Operating Instructions.
1.2 Target group
This document is addressed to technicians (persons with technical understanding)
operating and maintaining the measuring system.
The technicians must have been trained on the device.
Requirements for the technician
•
The technician must be familiar with the exhaust gas technology on the ship (over‐
pressure, toxic and hot flue gases) and be able to avoid hazards when working on
gas ducts.
•
The technician must be familiar with handling compressed gas cylinders (test
gases).
•
The technician must be able to avoid hazards caused by noxious test gases.
•
Only allow an authorized electrician to work on the electrical system or electrical
subassemblies.
1.3 Further information
•
“MARSIC200” Operating Instructions
•
Sampling Probe Operating Instructions
•
Instructions for laying the sample gas line
•
Sample Gas Cooler Operating Instructions
•
GMS800 BCU Operating Instructions
•
GMS800 Technical Information
•
Optional: MPR (Meeting Point Router) Operating Instructions
•
System documentation (parts list, device data, wiring diagram, system-relevant
components)
1.4 Symbols and document conventions
1.4.1 Warning symbols
Table 1: Warning symbols
Symbol Significance
Hazard (general)
Hazard by voltage
1 ABOUT THIS DOCUMENT
6
T E C H N I C A L I N F O R M A T I O N | MARSIC200 8017324/15A2/V6-0/2019-10 | SICK
Subject to change without notice

SICK MARSIC200 Specifications

General

Brand	SICK
Model	MARSIC200
Category	Measuring Instruments
Language	English