11.4 Replacing the Electronics module filter pad
Overview
Figure 19: Electronic housing (right side)
Important information
NOTICE
Dirt can get into the device when replacing the filter pad.
b
Only replace the filter pad when the device is switched off.
Prerequisites
•
The device is switched off.
Procedure
1.
Pull cover 1 off.
2. Replace the filter pad inside.
TROUBLESHOOTING 11
8021889/1D1T/V3-1/2021-09 | SICK O P E R A T I N G I N S T R U C T I O N S | MCS200HW
57
Subject to change without notice
To Next Page
Loading...
