2. Clean device.
3. Fill in the Repair Form including the Non-Risk Declaration and send it in advance
to the SICK representative by e-mail.
4. Pack the unit carefully and shockproof in the original packaging for transport.
5. Enclose the Repair Form and attach it to the outside of the packaging.
12.2.2 Cleaning the device before returning
Important information
NOTICE
Device damage through incorrect cleaning.
•
Close the housing before cleaning so that no fluid can penetrate.
•
Do not use a high-pressure cleaner, aggressive mechanical or chemical cleaning
agents.
Prerequisites
•
Device is voltage-free.
Procedure
Clean surfaces and parts with media contact
1. Remove loose contamination with compressed air.
2. Remove adhering contamination with a mild soap solution and a soft cloth.
3. Do not clean optical surfaces.
12.3 Transport
Procedure
1. Protect the device before transport.
2. Use the original packaging for transport or alternatively a suitable padded stable
packaging.
A transport container with adequate stability can also be used.
3. Protect the device with padding from shocks and vibrations.
4. Thoroughly secure the device in place inside the transport container. Make sure
there is sufficient space between the analyzer and the walls of the transport
container.
12.4 Disposal
Important information
NOTE
The following subassemblies contain substances that may have to be disposed of
separately:
•
Electronics: Capacitors, rechargeable batteries, batteries.
•
Display: Liquid of LC display.
•
Sample gas filter: Could be be contaminated with pollutants.
•
All lines with sample gas contact could be contaminated with pollutants.
Disposal of the device
The device can easily be disassembled into its components which can then be sent to
the respective raw material recycling facilities.
DECOMMISSIONING 12
8021889/1D1T/V3-1/2021-09 | SICK O P E R A T I N G I N S T R U C T I O N S | MCS200HW
59
Subject to change without notice
To Next Page
Loading...
Need help?
General
