Siemens 8DJH

500-8067.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DJH • Revision 05 49/121
Installation
11.3 Completeness and transport damage
Checking for
completeness
➭ Check whether the delivery is complete using the delivery notes and packing lists.
➭ Compare the serial number of the switchgear printed on the delivery note with the serial
number on the packing and the serial number on the rating plate.
➭ Check whether the switchgear accessories are complete.
Transport damages ➭ Temporarily open the packing in a weatherproof place to detect hidden damages. In order
to prevent pollution of the switchgear, do not remove the PE foil completely until reaching
the final mounting position.
➭ Check the switchgear for transport damages.
➭ Check service readiness (see page 57, "Checking service readiness").
➭ Refit the packing at the best.
➭ Determine and document detected defects and transport damages immediately, e.g. on the
freight documents.
➭ Document larger defects and transport damages photographically.
➭ Please contact the regional Siemens representative in order to repair the transport damages.
11.4 Intermediate storage
For intermediate storage of delivered switchgear, parts of the switchgear or accessories
before installation, select a suitable storage place.
DANGER
Risk of injury and damage to the storage place and the stored goods if the storage space is
overloaded.
➭ Observe the load-bearing capacity of the floor.
➭ Do not stack the transport units.
➭ Do not overload lighter components by stacking.
ATTENTION
Fire risk. The transport unit is packed in flammable materials.
➭ No smoking.
➭ Keep fire extinguishers in a weatherproof place.
➭ Mark the location of the fire extinguisher.
ATTENTION
If the supplied desiccant bags are not stored in the undamaged original packings, the desiccant
bags lose their effectiveness.
➭ Do not damage or remove packing of desiccant bags.
➭ Do not unpack desiccant bags before use.