Installation
82/121 Revision 05 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DJH • 500-8067.9
Documenting the
commissioning
➭ Document the modifications occurred during installation or commissioning.
➭ Document the modifications in the circuit diagram.
➭ Send the modifications to the regional Siemens representative.
After commissioning ➭ Observe the Five Safety Rules for working in the switchgear:
- Isolate.
- Secure against reclosing.
- Verify safe isolation from supply.
- Earth and short-circuit.
- Cover or barrier adjacent live parts.
➭ Observe the locally applicable specifications for prevention of accidents.
➭ If after commissioning further work is required in the area of the switchgear, install warning
signs on the switchgear.
Access for working in the area of the switchgear must only be granted to the following
persons:
- Electricians and persons who have been properly instructed in electrical engineering
- Persons under the supervision of electricians and persons who have been properly
instructed in electrical engineering
To Next Page
Loading...
