EasyManua.ls Logo

Siemens Hipath 5000 - Page 71

Siemens Hipath 5000
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alphabetical Reference
71
• Default value  Page 109.
 Page 29  Page 58
Codec Independent Threshold Values
• Max jitter threshold (in ms): The jitter will be compared with this
threshold. The jitter will be measured between two consecutive RTP
packets.
– Valid values: 1 ... 255
– Default value  Page 109.
• Avg round trip delay threshold (in ms): Round trip delay is the sum of
the runtimes in both directions.
– Valid values: 1 ... 65535
– Default value  Page 109.
 Page 64
Compression
• Chose the compression mode that has to be used if  Codec "Low
bandwidth only" was selected ( G.723 or  G.729).
• Default value  Page 109.
 Page 30  Page 58
Compressing Codec Threshold Values
• Packed  Codec
• Lost packet thresholds [per th]: Packets that got lost for voice
decoding. This value is the ratio of lost packets to the total number of
packets.
– Valid values: 1 ... 255
– Default value  Page 109.
• Consecutive lost packets [in packets]: the lost packets in succession
between two good packets will be counted. If the number of counted
packets is greater than the specified value, the threshold will be
exceeded.
– Valid values: 1 ... 255
– Default value  Page 109.
Codec Audio Mode Usage
High
quality
preferred
Uncompressed audio
transmission.
Use uncompressed audio
transmission ( G.711).
Suitable for broadband Intranet
connections.
Low
bandwidth
preferred
Use preferred
compressed audio
transmission.
Suitable for connections with
different bandwidths.
Low
bandwidth
only
Use compressed audio
transmission
exclusively.
Suitable for connections with
low bandwidth.

Table of Contents

Other manuals for Siemens Hipath 5000

Related product manuals