Siemens Hipath 5000 - Page 73

Alphabetical Reference
73
Debug Mode
• Only on optiPoint 410/420 standard/advance in conjunction with a
display
module or application module.
• This setting is required for application developers.
• Please do not change this setting.
 Page 57
Debug Program on Server
• Only on optiPoint 410/420 standard/advance in conjunction with a
display
module or application module.
• This setting is required for application developers.
• Please do not change this setting.
 Page 57
Default Route
• Enter the  IP Address that was assigned to your  PBX if no
 DHCP server assigns this value dynamically.
• If the value was assigned dynamically, it can only be read.
• A restart is necessary after the change.
• Default value  Page 109.
• IP editor on optiPoint 410/420  Page 106.
 Page 23  Page 18  Page 62
Default SNTP IP
• This entry is only required if you selected "SNTP" in the  Time Source
field.
• Enter the  IP Address of the  SNTP server.
 Page 67
Default VLAN ID
• Can only be defined if  Layer 2 support is activated ( QoS L2/L3).
• Enter a value from 0 to 4095 here. This value describes the association
with a certain VLAN if a
 VLAN is used.
 Page 23  Page 18  Page 62
Delete Program
• Only on optiPoint 410/420 standard/advance in conjunction with a
display
module or application module.
• Delete the selected program.
 Page 57