Siemens LME7 Series - Meaning of Symbols on the Display; Special Functions; Manual Lockout

55/106
Building Technologies Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 17.04.2018
13.2 Meaning of symbols on the display
P
Vh
min
s%
Parameter setting mode
Info mode
Service mode
Actuator closing
Actuator opening
Fan motor controlled
Oil preheater on
Heat request from controllers
Ignition controlled
Valve controlled
Flame present
Fault status message
Unit of current display
Bild 2e/0807
Figure 18: Meaning of display
13.3 Special functions
13.3.1 Manual lockout
/reset
plus any other
button
Press
/reset
together with any other button.
The basic unit switches instantly to the lockout
position, no matter what the operating position.
Display shows the fault status message.
(See chapter Error code list …)
Display: Loc: 167
The reset must be carried out as follows:
/reset
1 s
When the
/reset
button is pressed for 1 second,
rESEt appears on the display.
When the button is released, the basic unit is
reset.