Siemens LME7 Series - 13.7 Service Level

66/106
Building Technologies Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 17.04.2018
13.7 Service level
The service level is used to display information about errors including the error history.
Β
Note!
When on the service level, you can press or to display the next or the previous
parameter.
Instead of pressing , you can also press
/reset
for <1 second.
Β
Note!
Press
ESC
or
/reset
for >8 seconds to return to the normal display.
Β
Parameter
Parameter value
Figure 21: Service level
Note!
No change of values on the service level.
If characters are displayed by the parameter,
the value may consist of more than 5 digits.
Press
/reset
for >1 s and <3 s to display the value.
Press
/reset
for >3 s or
ESC
to return to the
selection of the parameter number (flashing).
13.7.1 Display of the service level
/reset
P
Vh
min
s%
Bild21/0707
Press
/reset
for >3 s until SEr appears.
When releasing
/reset
, you are on the service level.
No.
Parameter
Service level
920 Current PWM signal fan
936 Normalized speed
951
Mains voltage
954 Flame intensity