Siemens LME7 Series - Page 75

75/106
Building Technologies Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 17.04.2018
Press for value 1.
Display: Value 1 blinks
/reset
Press
/reset
to activate the backup process.
Display shows run
<3 s
After approx. 3 seconds (depending on the duration of the
program sequence), the displays shows bAC End and
signals the end of the backup process.
Display: bAC End
It will now be displayed for 2 minutes, or can be finished by pressing the
/reset
button
→
<2
min
or
/reset
Display shows OFF when the backup process is finished.
Β
Note:
During backup, all settings and parameters are transferred from the basic unit’s memory to the
memory of the program module.
Warning!
If any parameters are changed, a backup must be made! If this is not observed, there is a
risk of loss of safety functions.