Installing/mounting
5.1 Installing the CMK2000
CMK2000
30 Operating Instructions, 11/2015, A5E34877550B/001
Mounting on a control panel / wall
Proceed as follows:
1. Move the sliders
① to the outside until they latch in place.
2. The dimensions for the holes are shown in the following picture. Hole for M4 screw,
tightening torque 0.8 Nm to 1.2 Nm.
Image 5-2 CMK2000 wall mounting
If the CMK2000 is not mounted on the wall, the mounting sliders must always be left in the
factory-set positions, i.e. within the range shown in the above picture. Otherwise the
mounting sliders could become deformed if they are exposed to hot and moist ambient
conditions for a longer period of time.
To Next Page
Loading...
