Siemens LOGO! CMK2000 - Configuring and commissioning using ETS; Software and Hardware Requirements (ETS); Overview of ETS Configuration Steps

CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
39
Configuring and commissioning using ETS
8
8.1
Software and hardware requirements (ETS)
Requirements
● A commissioning PC is connected via a KNX interface to the CMK2000.
● ETS (Version 4 or higher) is installed on the PC.
ETS product database
The product database for the LOGO! CMK2000 KNX module is available starting with ETS 4
as a knxprod file for downloading.
● http://www.siemens.com/gamma-td (search text "LOGO")
8.2
Overview of ETS configuration steps
Listed below are the steps which always have to be carried out to configure the CMK2000
via ETS:
Offline configuration steps without connection to KNX
1. Importing of product database of LOGO! CMK2000 KNX module in ETS
2. Creation of an ETS project and insertion of the device into the project
3. Checking or specifying the physical address using the assignment according to the KNX
topology (e.g. 1.1.1)
4. Editing the parameters (IP address, data types, etc.)
5. Assigning the group addresses
Online configuration steps with connection to KNX
1. Loading to the device
(programming of physical address and the application)
2. Testing the function