Configuring and commissioning using ETS
8.4 General parameter assignments
CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
41
General parameter assignments
All KNX products can be configured and assigned parameters using the ETS. Depending on
the parameter assignments, the device makes available communication objects with
standardized data point types (DPT) for data exchange with other KNX devices.
The following general settings of the CMK2000 can be parameterized:
● IP address of the LOGO! base module
● Update rate for data exchange between CMK2000 and LOGO!
● Network parameters of the CMK2000 (IP address, subnet mask)
● Password for logon with web server
● Date and time synchronization
The parameters are transferred by ETS to the CMK2000 and saved there permanently.
Image 8-1 General settings
IP address of LOGO! base module
In this field you enter the IP address of the LOGO! which is to be used for data exchange.
This parameter defines the minimum delay time between two transmission cycles.
Note
Sudden changes in value in the LOGO! occurring within a transmission c
ycle may not be
recorded in certain circumstances and therefore not transmitted.
To Next Page
Loading...
