Siemens LOGO! CMK2000 - Transferring Integer Values

Configuring and commissioning using ETS
8.7 Data transfer KNX to LOGO!
CMK2000
74 Operating Instructions, 11/2015, A5E34877550B/001
8.7.7
Transferring integer values
Image 8-25 KNX to LOGO! integer values
KNX data type / LOGO! data type
KNX data type
LOGO! data type
1 byte unsigned - DPT 5.010
1-byte variable memory
1 byte signed - DPT 6.010
1-byte variable memory
2 bytes signed - DPT 8.xxx
2-byte variable memory
2 bytes unsigned - DPT 7.xxx
• Analog flag
• 2-byte variable memory (default)
4 bytes unsigned - DPT 12.xxx
4-byte variable memory
4 bytes signed - DPT 13.xxx
4-byte variable memory
See also
Value scaling of the channels (Page 48)
Response upon loss of KNX bus voltage (Page 51)
Response after startup of LOGO!, CMK2000 or KNX (Page 51)