Generation of user functions with LOGO!
7.3 Compatibility with LOGO! 0BA7 projects
CMK2000
38 Operating Instructions, 11/2015, A5E34877550B/001
Compatibility with LOGO! 0BA7 projects
The following describes how you can proceed with existing LOGO! 0BA7 projects.
LOGO! 0BA7 projects can be used further.
Changes are only required for the communication direction KNX → LOGO!.
Direct writing to analog or digital inputs and outputs by the KNX module is no longer
possible.
Analog outputs to be written can therefore be alternatively linked to analog flags or analog
network inputs.
Digital outputs can be linked to digital flags or digital network inputs.
Note
Compatibility of the special functions (e g. dimming, solar protection control) is not assured.
To Next Page
Loading...
