Configuring and commissioning using ETS
8.7 Data transfer KNX to LOGO!
CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
73
Transferring percentage values
Percentage values with DPT 5.001 are transferred to KNX as 1-byte values and must
therefore be rescaled so that they can be optimally processed further as LOGO! analog
values.
Image 8-24 Data transfer from KNX to LOGO!: Percentage values
KNX data type / LOGO! data type
1 byte 0…100% - DPT 5.001
Value scaling of the channels (Page 48)
Response upon loss of KNX bus voltage (Page 51)
Response after startup of LOGO!, CMK2000 or KNX (Page 51)
To Next Page
Loading...
