Configuring and commissioning using ETS
8.6 Transfer of data from LOGO! to KNX
CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
63
Transferring percentage values
Percentage values are handled in the LOGO! in the range 0...255. Percentage values DPT
5.001 are frequently used in KNX, where the values for KNX are expected in the range
0...255. Scaling is therefore necessary.
Image 8-14 Data transfer LOGO! to KNX: Percentage values
"1-byte variable memory" is predefined as the LOGO! data type.
1 byte 0…100% - DPT 5.001
The values transferred to KNX are in the range 0 ... 255.
To Next Page
Loading...
