Configuring and commissioning using ETS
8.6 Transfer of data from LOGO! to KNX
CMK2000
62 Operating Instructions, 11/2015, A5E34877550B/001
Slats open / close (short setting up to 500 ms) - DPT 1.009
The "Stop" or "Slats open / close" commands are sent via the group address linked to this
object. Short setting of the corresponding binary tags in the LOGO! always generates a
command to stop the movement or adjust the slats by one step. Which of the binary tags
generates an open or close message frame in the case of short setting can be set in the
ETS.
To Next Page
Loading...
