Siemens LOGO! CMK2000 - Transfer of 1-Bit Values

Configuring and commissioning using ETS
8.6 Transfer of data from LOGO! to KNX
CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
55
8.6.3
Transfer of 1-bit values
Image 8-7 Data transfer LOGO! to KNX: 1-bit values
LOGO! data type
Set a 1-bit LOGO! data type as the preselection for the transfer:
● Digital input
● Digital output
● Digital flag
● 1-bit variable memory
KNX data type
1 bit - DPT 1.xxx
The output information of the LOGO! 8 is mapped 1:1 to the KNX bus:
See also
Response after startup of LOGO!, CMK2000 or KNX (Page 51)