Configuring and commissioning using ETS
8.6 Transfer of data from LOGO! to KNX
CMK2000
Operating Instructions, 11/2015, A5E34877550B/001
57
Dimming (long setting 500 ms or more) - DPT 3.007
With long setting, dimming is brighter or darker depending on the object value and the last
controlled dimming direction. If the dimming actuator was switched off, long setting results in
brighter dimming. If the actuator was switched on by short setting, the first long setting
results in darker dimming. If the dimming actuator is set to a dimming value between 0 and
100%, the last dimming direction is inverted and dimming is then in the new direction. The
"Stop" command is sent when the binary value is reset (= falling edge).
Note
When configuring the first respective communication object for 1
-bit dimming and 1-bit solar
protection, the check mark for
“Update" must be set in the ETS so that the channel functions
properly, especially when starting.
Image 8-9 Check mark for “Update" set
To Next Page
Loading...
