5 System Parameters International English
MICROMASTER 440 Operating instructions
66 6SE6400-5CA00-0BP0
Par. No. Parametername Default Acc WS QC
P2261 PID setpoint filter timeconstant 0.00 3 CUT N
r2262 CO: Act. PID filtered setpoint - 3 - -
P2263 PID controller type 0 3 CT N
P2264[3] CI: PID feedback 755:0 2 CUT N
P2265 PID feedback filter timeconstant 0.00 2 CUT N
r2266 CO: PID filtered feedback - 2 - -
P2267 Max. value for PID feedback 100.00 3 CUT N
P2268 Min. value for PID feedback 0.00 3 CUT N
P2269 Gain applied to PID feedback 100.00 3 CUT N
P2270 PID feedback function selector 0 3 CUT N
P2271 PID tranducer type 0 2 CUT N
r2272 CO: PID scaled feedback - 2 - -
r2273 CO: PID error - 2 - -
P2274 PID derivative time 0.000 2 CUT N
P2280 PID proportional gain 3.000 2 CUT N
P2285 PID integral time 0.000 2 CUT N
P2291 PID output upper limit 100.00 2 CUT N
P2292 PID output lower limit 0.00 2 CUT N
P2293 Ramp-up /-down time of PID limit 1.00 3 CUT N
r2294 CO: Act. PID output - 2 - -
P2350 PID autotune enable 0 2 CUT N
P2355 PID tuning offset 5.00 3 CUT N
http://nicontrols.com
To Next Page
Loading...
