Siemens MOBILETT Plus HP - Replacing the Supporting Wheels

MOBILETT Plus HP SPR8-220.061.03 Page 24 of 28 Siemens AG
Rev. 03 09.03 CS PS 24 Medical Solutions
10 - 24 Mechanical systems
Replacing the supporting wheels 10
• Jack up the unit with the piece of wood.
• Block the rear wheels so that they cannot turn.
• Remove the locking rings (pos. 1 / Fig. 26).
• Remove the wheel shaft so that the supporting wheel can be removed.
• Install the new support wheel and secure the shaft with the locking ring.
• Check that the wheels move easily.
• Remove the wood block and lower the unit.
Equipment required: 1 piece of wood (approx. 50 x 70 x 500 mm)
Fig. 26
MOB00612
1