Siemens MOBILETT Plus HP - Replacing the Friction Linings; Replacing the Horizontal Friction Lining

Mechanical systems 10 - 25
Siemens AG SPR8-220.061.03 Page 25 of 28 MOBILETT Plus HP
Medical Solutions Rev. 03 09.03 CS PS 24
Replacing the friction linings 10
Replacing the horizontal friction lining 10
• Remove the joint covers.
• Remove the locking nut.
• Remove the screw and disc springs.
• Replace the horizontal friction lining.
• Remount the screw and disc springs (Fig. 27). Secure the screw with the locking nut.
• Adjust the horizontal friction linings. Refer to the section: "Adjustment of the friction
linings", Page 10 - 4.
• Reattach all covers.
Fig. 27
Locking nut
Disc springs
Friction lining