Siemens MOBILETT Plus HP - Tension Adjustment

Motor drive units 11 - 3
Siemens AG SPR8-220.061.03 Page 3 of 8 MOBILETT Plus HP
Medical Solutions Rev. 03 09.03 CS PS 24
Tension adjustment 11
• Loosen the screws (A/Fig. 4). The tension of the transmission belt can then be adjusted
with a 13 mm wrench.
• Press the special adjustment device to the transmission belt and hold a finger on top of it.
When the button (C/Fig. 5) is in the same level as the top of the adjustment device, a
proper pressure is applied.
Fig. 4 Fig. 5
C
MOB00460
A
1 - 1.5 mm