Siemens OptiPoint 410 - Conferencing; Introducing the Conference; Ending the Conference

Step by Step
Operating the Telephone with the Display
38
Conferencing
This feature is sometimes known as three-way calling.
Prerequisite: You are conducting a consultation call
( page 36).
Introducing the Conference
Prerequisite: You are conducting a consultation call
( page 36).
> : Select and confirm. The following appears in the dis-
play: "Creating local Conf.
"
"In Conference" appears on the display.
Ending the Conference
Changing back to single-line calls
> : Confirm.
You are reconnected with the first party. The second
party is placed on hold. You can now:
• alternate between the two parties;
• connect the two other parties (transfer);
• re-enter the conference call;
• terminate the active call – you are connected to the
second party.
or End both calls using the menu
> : Select and confirm. Both calls are terminated, and the
display shows "Cleared". You can start a new call.
or End both calls by hanging up
Prerequisite: "Allow Join in conference" was deactiva-
ted by the service personnel.
t Replace the handset or press the loudspeaker key (in in
speakerphone mode). The display shows "Cleared".
You can start a new call.
You can’t use this function with optiPoint 410/
420 economy/economy plus
Create local Conf.? >
Local Conf. disconnect? >
Clear both calls? >