Commissioning
6.3 Parameterizing the device
Equipment Manual, 09/2022, L1V30415168B-03
61
"Password protection" parameter
Write access is only possible if password information is used.
The password is only required when the "Password Protection" parameter is activated. As
soon as the password has been entered once for the device, it is not requested again. The set
password can be deleted from the memory in menu item "Password management".
Selection Range Factory
Valid for one device only.
•
Password protection is deactivated.
• ON: Write access is password protected by means of
Password policy: Four-digit number between 0000-9999
(default setting 0000)
Simultaneously unlocks multiple devices in which the "Global
password" has been defined.
•
Password protection is deactivated.
• ON: Write access is password protected by means of
Password policy: Four-digit number between 0000-9999
(default setting 0000)
Activation or deactivation of the password protection must be confirmed on the device.
The Power LED on the device flashes for 15 minutes. By pressing the SW button on the device
during this flashing period, the protection function is activated or deactivated.
If the password protection is entered incorrectly, this action can only be repeated after a
short delay. Every repeated incorrect password entry results in an extension of the delay
period between entry possibilities.
Note
Before switching on password protection, make sure that you and the group of authorized
users are
all in possession of the password.
If password protection is switched on, you need the password for all changes to the device
settings. You also require the password to call the "PASSWORD" dialog box again in order to
switch off access protection or to change the password.
Note
If you have forgotten the password, please contact Technical Assistance. You will receive a
new password from them.
To Next Page
Loading...
Need help?
General
