Siemens SENTRON PAC3200T - Service and maintenance; 7.1 Cleaning; 7.2 Calibration; 7.3 Firmware updates

Commissioning
6.3 Parameterizing the device
Equipment Manual, 09/2022, L1V30415168B-03
71
"Power demand" parameter
The "power demand" parameter permits the following device settings:
Selection
Range
Factory setting
Time period
The time period records the duration of the period in minutes.
Range: 1 min to 60 min
1
Synchronization
mode
Setting of the synchronization mode:
• No synchronization:
Switches "Synchronization via Bus" off. Synchronization only takes place after
time set internally in device.
• Synchronization via Bus:
Activates "Synchronization via Bus". Deactivates "Synchronization via Digital
Input" or "Synchronization via internal clock".
• Synchronization via Digital Input:
Activates "Synchronization via Digital Input". Deactivates "Synchronization via
Bus" or "Synchronization via internal clock".
• Synchronization via internal clock:
Activates "Synchronization via internal clock". Deactivates "Synchronization via
Bus" or "Synchronization via Digital Input".
1