RF Controls
17
Siemens Building Technologies
Fire Safety & Security Products 07.2009
4. Carry out the required function by pressing a button sequence:
Button Sequence
901# Toggle remote control output 1
902# Toggle remote control output 2
910# Unset partition 1
911# Full set partition 1
912# Part set partition 1
920# Unset partition 2
921# Full set partition 2
922# Part set partition 2
.. ..
960# Unset partition 6
961# Full set partition 6
962# Part set partition 6
The buttons 9 and # are used for the following function:
Button Function
9 Deletes the entry
# The operation is transmitted to the control unit and one
beep tone is heard.
If the operation can not be transmitted to the control unit,
two beep sounds are heard.
5 RF Controls
5.1 Partition
Assign the “partition rights” for each partition.
5.2 Partition Rights
Select the partition for the assigned “partition rights”.
O: Forced Set The user can force the partition to set with inputs (zones) which are not in normal state. If you want to use
this function, you have to define the inputs as bypass able.
U: Unset The user can switch the partition to unset state.
P: Part Set The user can switch the partition to part set state.
F: Full Set The user can switch the partition to full set state
1: Button 1 This right is assigned to the output logical function “Radio Remote Control Button 1”
2: Button 2 This right is assigned to the output logical function “Radio Remote Control Button 2”
To Next Page
Loading...
