Input Transmission
81
Siemens Building Technologies
Fire Safety & Security Products 07.2009
15.2 Service 1 & 2
Transmission to Sylcom or as SMS
Service 1 and 2 This parameter defines whether or not the last 10 events of the engineer log is to be transmitted to
service station 1 after triggering of a transmission line. Two different options can be chosen for this
transmission.
z Immediate transmission after triggering of the transmission line.
z Transmission only on unset.
"Service transmission" parameter in the "Other Telecom Options" (TM65)in the engineer menu.
This parameter applies to both stations.
Transmission On full set: All programmed transmission lines are transmitted.
NOTE
Service 2 is used to send SMS to a mobile phone. For this, the according input lines must be en-
abled for transmission.
For this feature the SMN43 is required.
To Next Page
Loading...
