Alarm, Error and System Messages
12.2 BIOS POST codes
SIMATIC Box PC 627
12-4 Operating Instructions, Release 05/2006, A5E00362052-03
Special codes
The following Beep codes are available in addition to the listed POST codes:
• 3 x short INSERT key is pressed on system start:
If an external graphics card on the bus board is not detected, you can try to activate it by
pressing the INSERT key.
The "INSERT" key activates special enumerations for activating a PCI VGA card.
• 1 x long 8 x short Error on reading the MPI system information:
Please contact Customer Support
• 4 x short MPI firmware has been updated:
This can occur once following a BIOS update.
• 2x short Error in checksum test of the BIOS:
This can occur following a battery replacement or when the battery is empty.
To Next Page
Loading...
