Siemens Simatic box pc 627b - Setting up the Operating System Via the Recovery CD

Maintenance and service
11.2 Reinstalling the Operating System
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
11-21
Setting up the language selection for Windows 2000 MUI
The Multilanguage User Interface (MUI) allows you to set up the Windows 2000 menus and
dialogs for additional languages.
To set the required languages for the Windows 2000 menus, dialogs and keyboard layout,
select:
Start > Settings > Control Panel > Regional Options > General tab, Setting for the current user field
and Language settings for the system field and the Keyboard layout field in the Input Locales tab.
The default language setting of your Windows 2000 installation is English and a US
keyboard layout. To change to another language and keyboard layout, open the Control
Panel and select:
Start > Settings > Control Panel > Regional Options >General tab, Setting for current user field and
Language settings for the system field and the Input language field in the Input Locales tab.
In addition to the menu and dialog language settings, you also need to set the default
language by selecting Set Default... from the Regional Options dialog box.
11.2.2.3 Setting up the operating system via the Recovery CD
Use the Recovery CD to install Windows to meet your special requirements. The operating
system used is Windows Preinstall Environment (WinPE). You will also need the supplied
Documentation and Drivers CD.
Booting with the CD Recovery
1. Insert the Recovery CD in your drive and reboot the device. When the BIOS message
”Press <F2> to enter Setup or <ESC> to show Boot Menu"
appears, press the ESC key. After initialization, a "Boot Menu" is displayed.
2. Follow the on-screen instructions until the "Siemens SIMATIC Recovery" window
appears.
Partition setup
After you have installed a new hard disk, or if partitions are faulty, or when you wish to
change the partitioning on your hard disk, you need to create or reconfigure partitions on the
hard disk
Caution
When you delete or create partitions or logical DOS partitions, you lose all data on the hard
disk. All partitions on the hard disk will be deleted.