Siemens Simatic box pc 627b - Page 92

Maintenance and service
11.2 Reinstalling the Operating System
SIMATIC Box PC 627
11-20 Operating Instructions, Release 05/2006, A5E00362052-03
Restoring the factory state
To restore the factory state, proceed as follows:
1. If the device does not have an optical drive, connect a USB DVD-ROM drive to the device.
2. Insert the Restore DVD in the drive and reboot the device. When the BIOS message
appears, press
<F2> to enter SETUP or <ESC> to display the boot menu
the F2 key.
3. Select the Boot menu and move the entry "CD-ROM Drive" to the first position.
4. End the BIOS setup with the "Exit Saving Changes" entry.
5. Now follow the instructions on the screen.
Caution
All existing data, programs, user settings and authorizations or license keys will be deleted
from the hard disk and therefore lost.
For information on the functions, refer to the README.TXT file on the Restore DVD.
Note
The "Legacy USB Support" option has to be set to "Enabled" in the Advanced menu of the
BIOS so that the device can address a USB DVD-ROM drive.
Setting up the language selection for Windows XP Professional
The Multilanguage User Interface (MUI) allows you to set up the Windows XP Professional
menus and dialogs for additional languages.
Default language of your Windows XP MUI installation is English and a US keyboard layout.
You can change the language in the Control Panel. Select:
Start > Control Panel > Regional and Language Options Languages,
tab Language used in menus and dialogs field.
For the Regional and Language Options set the default as non-Unicode programs under Advanced in
addition to the language for menus and dialogs.