Siemens Simatic box pc 627b - Installing PCI expansion cards

Expansions and configuration
10.3 Installing PCI expansion cards
SIMATIC Box PC 627
10-6 Operating Instructions, Release 05/2006, A5E00362052-03
10.3 10.3 Installing PCI expansion cards
10.3.1 Notes on the modules
The device is designed for use with modules conforming to PCI specifications V 2.2. PCI
modules with 5 V and 3.3 V supply voltage can be operated. The permitted dimensions of
the modules are found in the dimensional drawings section.
10.3.2 Installing / removing expansion modules
Preparation
Disconnect the device from mains.
Installing expansion modules
How to install an expansion module (PCI):
1 Open the device.
2 1 Remove the fastening screws (1)
and lift out the module bracket (2).
3 Remove the relevant steel slot
cover (5).
4 Insert the expansion module (4)
into the relevant slot.
Pay attention to the guide rail (6)
when using long PCI modules.
5 Install the module bracket and
insert the slider (3).
6 Screw down the steel slot cover (5)
for the expansion module.
7 Close the device.