Commissioning
7.5 Notes on operation
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
7-3
7.5 7.5 Notes on operation
7.5.1 DVD ROM/CD RW
The DVD-ROM/CD-RW drive is an optional feature. Recording methods supported by the
disk drive: Disc at once, Track at once, Session at once, Packet writing, whereby Disc at
once und Track at once are recommended due to their compatibility to other optical drives.
DVD-ROM, CD-ROM, CD-R and Video CDs can be read.
Burner/DVD player software
To utilize the full functionality of our DVD-ROM/CD-RW drive, you need to install additional
software (burning or DVD player software). This software is included on the CD supplied with
the device. Insert the CD in the drive, run setup and follow the instructions on the screen.
Information on burning CD-Rs/CD-RWs
Caution
Data may be corrupted when burning CD-R or CD-RW!
Burning is permissible only in an undisturbed environment, i.e. shock and vibration stress
must be avoided. Because of heavy fluctuation in the quality of CD-Rs, data may be
corrupted in a burning session, even if no error message is initially displayed. The written
data can only be verified by comparing these with the source. To be on the safe side, data
should be verified after every burning session. When backing up an image, the data should
be restored to the hard disk and the system should be rebooted from the hard disk.
7.5.2 2HDD/RAID system (optional)
The two hard disks are configured as follows in the factory state of the computer:
Hard disk 0 Hard disk 1
Partition C: System, NTFS, 10 GB
Partition D: System, NTFS, remaining capacity
Not configured
You can use the two hard disks as a 2 HHD system or as a RAID system.
To Next Page
Loading...
