Siemens Simatic box pc 627b - Page 147

Detailed descriptions
16.4 BIOS Setup
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
16-29
IDE Channel 0 Master, IDE Channel 0 Slave
The system jumps to the following submenu when you select this type of menu field:
,'(&KDQQHO0DVWHU>0%@
3KRHQL[%,266HWXS8WLOLW\
,WHP6SHFLILF+HOS
7\SH
(6& ([LW
6HOHFW,WHP
6HOHFW0HQX

6HOHFW
&KDQJH9DOXHV
6XE0HQX
)
)
6HWXS'HIDXOWV
6DYHDQG([LW
(QWHU
+HOS
)
0DLQ
>8VHU@
&+6)RUPDW
/%$)RUPDW
&\OLQGHUV >@
>@
>@
+HDGV
6HFWRUV
7RWDO6HFWRUV  
0D[LPXP&DSDFLW\
0D[LPXP&DSDFLW\ 0%
0XOWL6HFWRU7UDQVIHUV >'LVDEOHG@
/%$0RGH&RQWURO  >(QDEOHG@
7UDQVIHU0RGH  >)3,2'0$@
8OWUD'0$0RGH  >'LVDEOHG@
8VHU \RXHQWHU
SDUDPHWHUVRIKDUGGLVN
GULYHLQVWDOOHGDWWKLV
FRQQHFWLRQ
$XWR DXWRW\SHV
KDUGGLVNGULYH
LQVWDOOHGKHUH
&''9'520 &''9'520
GULYHLVLQVWDOOHGKHUH
$7$3,5HPRYDEOH
UHPRYDEOHGLVNGULYHLV
LQVWDOOHGKHUH
0%
Figure 16-3 IDE Channel 0 Master (example)
[User] Select “User” if you want to define the hard disk drive. You also
need to configure the other options, for example, Cylinder, Heads,
Sectors/Track, or other properties of the hard disk drive.
[Auto] The parameters that you can select here are usually stored on the
respective IDE drive. The 'Auto' setting in the 'Type' field means
that these values are automatically read from the drive and written
to memory.
If Type is selected for a drive that cannot be detected, a time-out is
triggered within approximately 1 minute and the entries remain
unchanged. You should always check that the interfaces for which
you select 'Auto' are in fact connected to drives.
[CD/DVD-ROM] CD/DVD-ROM is connected
ATAPI
Removable
This is where removable data media is connected
Type
None Select "None" if you have not connected a disk drive. This setting
reduces the system waiting time.
The number of sectors transmitted per interrupt are transferred in the option “Multi-
Sector Transfers.” The value depends on the drive and should be set only to "Auto" in
the "Type" field.
Multi Sector-
Transfer
Disabled 2,4,8,16 sectors