Siemens Simatic box pc 627b - Page 151

Detailed descriptions
16.4 BIOS Setup
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
16-33
"Boot Options" field
The following context menu appears when you select “Boot Options” in the main menu:
3KRHQL[%,266HWXS8WLOLW\
,WHP6SHFLILF+HOS
4XLFN%RRW0RGH
(6& ([LW
6HOHFW,WHP
6HOHFW0HQX

6HOHFW
&KDQJH9DOXHV
6XE0HQX
)
)
6HWXS'HIDXOWV
6DYHDQG([LW
6(783SURPSW >(QDEOHG@
3267(UURUV >$OOEXWQRWNH\ERDUG@
(QWHU
+HOS
)
0DLQ
>(QDEOHG@
6XPPDU\6FUHHQ
'LDJQRVWLFVFUHHQ
>(QDEOHG@
>(QDEOHG@
%RRW2SWLRQV
&RQWUROZKHUHWKH3RUW
KF\FOHVDUHFHQW
/3&%XV
3&,%XV
3267&RGH6WDWXV
>/3&%XV@
Figure 16-6 "Boot Options" field
Quick Boot Mode Some hardware tests are skipped to speed up the boot sequence.
SETUP prompt During the system load phase, the message "Press <F2> to enter Setup
or <Esc> to show boot menu"
is output on the bottom of the screen.
The boot sequence is stopped if an error is detected; you must press F1
to acknowledge.
[Disabled] No error confirmation is required, for example, when no
keyboard is connected.
POST Errors
[All, but not
keyboard]
Show all errors except for keyboard errors.
Summary screen The most important system parameters are displayed when the system
run-up phase completes.
Diagnostic screen Shows the diagnostics messages on the monitor during booting.
Post Code/Status Specifies where the POST codes are saved.
'Enabled' means that the feature is active. 'Disabled' means that the feature is inactive.