Commissioning
7.5 Notes on operation
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
7-7
8. Now select the hard disk to be used in the RAID 1 system. This is usually the hard disk
containing the operating system (default: Port 0). This hard disk is used as the source
and its data will later be mirrored to the partner drive.
9. Now select the partner drive where the data should be mirrored. This is usually an empty
hard disk (default: Port 2).
10. Select "Finish" and the RAID system is created.
To Next Page
Loading...
