Compatibilities between the IM 153-x
A.2 Compatibilities between the versions of IM 153-2 / -2 FO
ET 200M
244 Operating Instructions, 12/2008, EWA-4NEB780600602-08
Interface module with order number 6ES7153-…
2AA.. 2BA.. 2AB..
(FO)
2BB..
(FO)
Functions /
Properties
00 01 02 00 01/81 02/82 00 01 00
Identification and maintenance data (I&M) – – – x
(I&A)
x x – – x
(I&A)
Update via PROFIBUS DP – – – x
2
x x – – x
2
Update via SIMATIC Micro Memory Card – – – x – – – – x
RC network with 10 MΩ for unearthed
configuration
-
(1 MΩ)
as of
E03
x x x x x x x
DPV1 mode – – as of
E09
x x x – as of
E08
x
IQ-sense – – – x
(as of
FW
V3.0.1)
x x – – x
(as of
FW
V3.0.1)
E = module version
1
SYNC, FREEZE should not be used for these functions.
2
not when operating with the bus module BM IM/IM 6ES7195-7HD00-0XA0
3
supports expanded diagnostics with the 96-byte diagnostic frame in the spare part scenario
Retrofitting
You can retrofit the IM 153-2 with order number 6ES7153-2AA02-0XB0; module version 06
to the module version 07 - this is subject to a fee.
You can retrofit the IM 153-2 FO with order number 6ES7153-2AB01-0XB0, module version
05 to module version 06 - this is subject to a fee.
Contact your Siemens representative for this.
Behavior with inserting / removing interrupt
up to
153-2AA02, module version 06
153-2AB01, module version 05
as of
153-2AA02, module version 07
153-2AB01, module version 06
The ET 200M is set up on active bus modules.
The removal/insertion interrupt is disabled at
parameter assignment.
The removal or insertion of a module results in
station failure.
The ET 200M is set up on active bus modules.
The removal/insertion interrupt is disabled at
parameter assignment.
It is still, however, possible to remove and insert
modules. An interrupt is not reported, but the
events are displayed in the diagnosis.
To Next Page
Loading...
