Siemens simatic ET 200MP - Data Record Structure

Installation
5.4 Installing the interface module
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
47
Installing the interface module
Watch video sequence (http://support.automation.siemens.com/WW/view/en/67462859)
1. Place the U connector at the back right of the interface module (see following figure).
2. Install the interface module on the rail.
3. Pivot the interface module towards the back.



Figure 5-5 Installing the interface module
4. Fasten the interface module (torque 1.5 Nm).
Uninstalling the interface module
The interface module is wired, and is followed by additional modules:
1. Switch off the supply voltage for the interface module.
2. Open the front cover.
3. Loosen the bus connector and the connector for the supply voltage with the screwdriver,
and remove them from the interface module.
4. Loosen the fixing screw of the interface module.
5. Pivot the interface module out of the mounting rail.