Siemens simatic ET 200MP - 9 Maintenance; Removing and Inserting I;O Modules

ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
85
Maintenance
9
9.1 Removing and inserting I/O modules
Removing and inserting front connectors and I/O modules with live voltage is not allowed!
NOTICE
Physical damage can occur
If you install or uninstall front connectors and/or I/O modules with switched-on voltage, this
can lead to undefined conditions in your plant.
Physical damage to the ET 200MP may occur as a result.
Therefore only install/uninstall front connectors and/or I/O modules with switched-off
voltage.
Therefore during the planning of a plant always make sure to comply with the necessary,
pertinent standards and safety guidelines.