Siemens simatic ET 200MP - Resistance Thermometers Pt 100 and Pt 1000 Standard; Resistance Thermometers Pt 100 and Pt 1000 Climate

Wiring
6.4 Wiring rules
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
57
6.4 Wiring rules
Wiring rules
Table 6- 2 Wiring rules
Wiring rules for... Interface module 40-pin front connector
(screw-type connection)
Power supply module
- up to 0.25 mm
2
- Connectible conductor cross-sections for
solid wires
- AWG
*:
up to 24 -
0.25 to 2.5 mm
2
0.25 to 1.5 mm
2
1.5 mm
2
Without wire end
ferrule
AWG
*
: 24 to 16 AWG
*
: 24 to 16 AWG
*
: 16
0.25 to 2.5 mm
2
0.25 to 1.5 mm
2
1.5 mm
2
Connectible
conductor cross-
sections for stranded
wires
With wire end
ferrule
AWG
*
: 24 to 16 AWG
*
: 24 to 16 AWG
*
: 16
Number of wires per connection 1 1 or combination of 2
wires up to 1.5 mm
2
(total) in the same wire
end ferrule
1
Length of stripped wires 10 to 11 mm 10 to 11 mm 7 to 8 mm
Without plastic
sleeve
Design A, 10 mm long Design A, 10 mm and
12 mm long
Design A, 7 mm long End sleeves
according to
DIN 46228
With plastic sleeve
0.25 to 1.5 mm
2
Design E, 10 mm long Design E, 10 mm and
12 mm long
Design A, 7 mm long
Sheath diameter - - 8.5 mm
Tool 3 to 3.5 mm Phillips
screwdriver, conic
design
3 to 3.5 mm Phillips
screwdriver, conic design
3 to 3.5 mm Phillips
screwdriver, conic
design
Tightening torque - from 0.4 Nm to 0.7 Nm from 0.5 Nm to 0.6 Nm
* AWG: American Wire Gauge